Home > Lie-Nielsen Toolworks > Hand Planes > Bench Planes > Standard Bench Planes >

Lie-Nielsen No.8 Jointer Plane
Lie-Nielsen No.8 Jointer Plane

Our Price: $475.00

Quantity in Stock:3
Availability:: Usually Ships in 24 Hours
Product Code: A180

Description Tool Care

No. 8 Jointer Plane

The longest and heaviest of the bench planes, the No. 8 will flatten and true like no other. It is capable of precise joints and perfect flatness of large areas.

  • 24" long.
  • Blade is 2-5/8" wide x .170" thick.
  • Iron body.
  • 10 lbs.
  • Bench Planes

    Lie-Nielsen Bench Planes (except for the No. 1) are based on the Stanley Bedrock-type planes. Bedrocks were Stanley’s top line of Bench Planes, heavier and better made than the standard. In addition, the construction of the frog is unique — it features a fully machined fit between frog and body, adjustable from the rear without having to remove the blade and cap. This allows you to easily change the mouth setting from a coarse to fine cut for difficult woods or fine smoothing passes.


    All Bench Plane blades are bedded at 45° with the bevel down.

    Blade Sharpening:

    Your Lie-Nielsen Bench Plane is ready to cut wood out of the box. The blade is ground sharp at a 25° bevel. A secondary bevel of up to 5 degrees helps achieve a razor edge quickly. This also improves edge life in hardwoods.

    Mouth Adjustment:

    To adjust the mouth opening, loosen the two locking screws at the back of the frog; then turn the middle adjuster screw. Observe the opening in front of the blade. When it is correct, set the locking screws again.


    Our Chipbreaker is 1/8" thick. The raised lip under the bevel of the chip-breaker is back beveled 1° to ensure that the leading edge contacts the blade firmly. You should never need to dress this surface, but if you do, use a very fine stone and be sure to maintain the angle. The 25° bevel may be honed occasionally. For general work, set the end of the chipbreaker about 1/16" from the cutting edge of the blade; for the finest smoothing work, set it closer to the edge.

    Blade Adjustment:

    To advance the blade, turn the adjuster nut clockwise. It is always a good idea to finish adjusting the blade by a forward adjustment to take up backlash and to prevent the blade from moving. In order to be able to adjust the blade easily, do not overtighten the lever cap screw.

Lie-Nielsen Screwdriver No.5 - Handle Nut/ Cap Screw - Curly Maple Lie-Nielsen Screwdriver No.4 - Chipbreaker Screw - Curly Maple Lie-Nielsen Screwdriver No.7 - Frog Adjuster - Curly Maple Lie-Nielsen Extra Large Plane Sock
Our Price: $25.00
Our Price: $25.00
Our Price: $25.00
Our Price: $9.50
LN Screwdriver No.5 - Handle Nut/ Cap Screw - Curly Maple LN Screwdriver No.4 - Chipbreaker Screw - Curly Maple LN Screwdriver No.7 - Frog Adjuster - Curly Maple Lie-Nielsen Extra Large Plane Sock
Lie-Nielsen Tool Care Kit Lie-Nielsen Honing Guide
Our Price: $39.00
Our Price: $125.00
Lie-Nielsen Tool Care Kit LIe-Nielsen Honing Guide

Share your knowledge of this product. Be the first to write a review »