Home > Hand Tools > Chisels > Lie-Nielsen Chisels >

Lie-Nielsen Skew Bevel Edge Chisels
Lie-Nielsen Skew Bevel Edge Chisels


Skew Chisels

The same as our Bevel Edge Socket Chisels but with a left and a right hand skew for jobs like cleaning out the corners of dovetail pins.

Available in pairs 1/4" (6.35mm), 3/8" (9.52mm) and 1/2" (1.27cm).

  • Angle of skew 20 Degrees.
  • A2 Tool Steel hardened to Rockwell 60-62
  • Hornbeam handles

Item# Item Name Our Price Qty Add
ACBSQ500 Lie-Nielsen Skew Bevel Edge Chisels - 1/2"
(Out of Stock)
ACBSQ250 Lie-Nielsen Skew Bevel Edge Chisels - 1/4"
(Out of Stock)
ACBSQ375 Lie-Nielsen Skew Bevel Edge Chisels - 3/8"
(Out of Stock)
Check the items you wish to purchase, then click

  • Lie-Nielsen Chisels are based on the Stanley 750 Bevel Edge Socket Chisels. Socket chisels are not common these days, perhaps because they are expensive to make,but Stanley and others once produced socket chisels in a vast array. Socket chisel handles are less likely to break than tang chisels, and can be replaced easily. At 9" long, our chisels are particularly comfortable in the hand and have excellent balance.


    Our chisel edges are square, parallel along the length, and very narrow so you can get into tight places. The backs are ground flat and finished by hand at 400 grit. The bevel is flat ground at 30°, but a higher secondary bevel (about 35°) is advisable, depending on the wood and how the chisel is being used. Additional honing is recommended.


    Lie-Nielsen Chisels have Maine-harvested Hornbeam handles. Hornbeam, also known as Ironwood, was once prized for its toughness, but usually winds up as firewood these days. This under-utilized species makes superb chisel handles. Longer handles are available for paring — overall length is 13".

    Re-Seating Handles:

    When your Chisels arrive, the handles may be loose because of wood shrinkage. They may also loosen during dry weather. The handles are held in place by the wedging of the wood into the tapered socket. Just rap the chisel handle upside down to re-seat the handle (some people find loose handles annoying and prefer to glue them in).

    Removing Handles:

    One of the advantages of the socket design is that if you want to change handles, you can simply tap the side of the handle on a board and pop the handle off.


    Our chisels are made of A-2 Tool Steel, hardened to Rockwell 60-62, cryogenically treated and double tempered.

Tool Care:
  • Maintenance:

    Tool Steel can rust. To protect your chisels, you should oil, wax and/or wrap the tools after use. At the least, wipe your fingerprints off with an oily rag.


    Materials and workmanship are guaranteed for the life of your tool. Call for repairs or replacement parts. We are available for advice if you ever have a problem using your tool.


    Sharp chisels are dangerous and should be handled with care. Dull chisels are even more dangerous and should be sharpened.

WARNING: This product can expose you to lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go www.P65Warnings.ca.gov. Wash hands after handling.

Share your knowledge of this product. Be the first to write a review »